- #What is ide ata atapi controllers driver serial
- #What is ide ata atapi controllers driver Pc
- #What is ide ata atapi controllers driver mac
Not only did this result in integration issues, but the distance between the two could impact performance.
Before that, controllers and disks were implemented as separate devices, often built by different manufacturers. The IDE interface standard grew out of the effort to combine a storage controller and the storage disk into a single unit. A flat ribbon cable connected the drive to the motherboard by attaching to the IDE interfaces on the computer and HDD. The interface provided a 40-pin connector for attaching an IDE hard disk drive ( HDD) to the computer. At one time, most computers included at least one IDE interface built into the motherboard. What is an IDE interface?Īn IDE interface is an industry-standard adapter for connecting IDE devices and enabling them to communicate with each other. Only SATA stands apart from the others, even though it can be considered a type of ATA. As a result, IDE, ATA and PATA have all come to refer to the same technology, which continues to cause confusion across the industry.
#What is ide ata atapi controllers driver mac
For example, Apple uses ATA when describing resources on a Mac computer.Īt the same time, it's still quite common for the terms IDE and ATA to be used interchangeably. Vendors often use ATA to refer to the original technology.
#What is ide ata atapi controllers driver serial
The new standard brought with it a renaming of the original interface from ATA to Parallel ATA ( PATA) because it's based on parallel signaling technology, whereas SATA is based on serial signaling technology.ĭespite the new label, many continued to use ATA to refer to the first interface, while others started to use PATA. The introduction of Serial ATA ( SATA) - the command and transport standard that succeeded the first ATA - only muddied the waters further. Since then, it has become a generally accepted practice to treat them as one in the same, even if it could be argued that they are not. After ANSI standardized the technology, the terms ATA and IDE started to be used interchangeably. The IDE technology was developed in the 1980s by Western Digital and Compaq as part of an effort to combine the storage controller and drive into a single device.
The ATA standard is maintained by the T13 Committee of the International Committee on Information Technology Standards, an ANSI-accredited forum for creating technology standards. In November 1990, the American National Standards Institute ( ANSI) standardized the IDE technology, referring to it as Advanced Technology Attachment (ATA).
#What is ide ata atapi controllers driver Pc
The IDE interface was originally based on the IBM PC Industry Standard Architecture 16-bit bus standard, but it has since been implemented in computers that use other bus standards. IDE (Integrated Drive Electronics) is an electronic interface standard that defines the connection between a bus on a computer's motherboard and the computer's disk storage devices. What is IDE (Integrated Drive Electronics)?